Triumph Rocket III Classic Service Manual page 375

(
Z TIghten the two clips securing the intake plenum to
the intake duct.
1. Intake plenum
2. Intake duct
3. Clips
po~;itiiv ' e llly located to the throttle
bodies and intake duct and is retained by the clips
through their full circumference. Rectify if necessary as
poor engine performance and engine damage may
result from poor plenum/duct sealing.
8. Reconnect the MAP sensor hoses.
1. Map sensor hose to centre throHte body
2. Map sensor hose to sensor
Fuel System/Engine Management
9. Reconnect the MAP and air temperature sensors.
1.
MAP sensor
2. Air temperature sensor
3. Connectors
10. Position the battery box to the frame.
11. TIghten the battery box fixings to 9 Nm.
Note:
•
•
Rocket
III
and Classic continue from step
12
to
step 17. Then continue from step
22
to step
35.
Rocket
III
Touring continue from step
18
to
step
35.
Rocket
III
and Classic
12. Reposition the seat lock to the frame and battery
box. Tighten the lock fixings to 5 Nm.
13. On the right hand side, fit the two relays and sockets
to their mounting points on the battery box. Ensure
that both relays are fully engaged on their
mountings.
"' "
1. Relays
2. BaHery box
SelVice Manual - Rocket
1111
Classic
1
Touring
11.171