Triumph Rocket III Classic Service Manual page 578

Frame and Bodywork
8. Align the clamp upper split line with the punch mark
on the handlebar then evenly tighten the clamp bolts
to 15 Nm.
1. Clamp upper split line
2. Handlebar dot mark
9. Refit the left hand switchgear assembly, tightening
the screws to 3 Nm.
10. Refit the right hand switchgear assembly, tightening
the screws to
3 Nm.
11. Assemble the handlebar end weights into the
handlebar ends, and tighten the fixings to 8 Nm.
1. Handlebar
2. End weight assembly
12. Renew any damaged clips before refitting all wiring
and the front brake hose to the clips.
13. Check that the throttle opens and closes smoothly
without sticking. Rectify as necessary.
14. Refit the windscreen (see page
17-30>.
Operation of the motorcycle with incorrectly adjusted,
incorrectly routed or damaged throttle cables could
interfere with the operation of the brakes, clutch or the
throttle itself. Any of these conditions could result in loss
of control of the motorcycle and an accident.
Move the handlebars to left and right full lock while
checking that cables and harnesses do not bind or that
the steering feels tight or difficult to turn. A cable or
harness that binds, or steering that is tight/difficult to
turn will restrict the steering and may cause loss of
control and an accident.
17.36
SelVice Manual - Rocket Ill/ Classic / Touring