Triumph Rocket III Classic Service Manual page 165

4. Fit new Torx fixings to the bearing housing. Tighten
them to 12 Nm.
5. Using a small punch, stake the Torx heads to the
corresponding notches in the upper crankcase.
1. Torx fixings
2. Notches
3. Stake marks
6. Refit the selectors and shaft (see page
8-10>.
Transmission
Z Refit the output shaft to the crankcase ensuring the
snap-ring on the outside of the inner bearing locates
in their corresponding groove in the crankcase.
Installing the Output Shaft
8. Assemble the crankcases (see page 5-8>.
9.
Refit the engine to the frame (see page 10-5>.
SelVice Manual - Rocket Ill/ Classic / Touring
8.19