Table of Contents
Advertisement
Headlights
Adjust road speed to suit the visibility and weather
conditions in which the motorcycle is being operated.
Ensure that the beams are adjusted to illuminate the
road surface sufficiently far ahead without dazzling
oncoming traffic. An incorrectly adjusted headlight may
impair visibility causing an accident.
Never attempt to adjust a headlamp beam when the
motorcycle is in motion.
Any attempt to adjust a headlamp beam when the
motorcycle is in motion may result in loss of control and
an accident.
Note:
•
The vertical beams of the left and right hand
headlights can only be adjusted together.
Independent adjustment is not possible.
Headlight Vertical Adjustment - Rocket III and
Classic
1.
Vertical beam adjuster
1.
Turn the ignition switch to the ON position.
2.
Remove the ignition switch cover.
3.
Slacken the clamp bolt sufficient to allow restricted
movement of the headlights.
4.
Adjust the position of the headlights to give the
required beam setting.
5.
Tighten the clamp bolt to
15 Nm.
6.
Re-check the headlight beam settings.
Z
Refit the ignition switch cover.
Electrical System
8.
Turn the ignition off when both beam settings are
satisfactorily set.
Headlight Horizontal Adjustment - Rocket III
and Classic
@
1.
Horizontal beam adjuster
1.
The horizontal beams of both headlights can be
adjusted individually. The same procedure is used to
adjust either headlight.
2.
Turn the ignition switch to the ON position.
3.
Slacken the headlight bowl fixing.
4.
Adjust the horizontal position of the headlight to give
the required beam setting.
5.
Tighten the fixing to
20 Nm.
6.
Repeat for the second headlight.
Z
Re-check the headlight beam settings.
8.
Switch the ignition off when both beams are
satisfactorily set.
SelVice Manual- Rocket
1111
Classic
I
Touring I Touring
18.17
Advertisement
Chapters
Table of Contents
