Side Panel - Installation - Triumph Speed 400 Owner's Handbook Manual

Lift the side panel upwards to
▼
remove from the lower hook.
2
clgc
1. Side panel (Scrambler 400 X shown)
2. Hook
3. Grommets

Side Panel - Installation

WARNING
Make sure the motorcycle is stabilized
and adequately supported.
Do not support the motorcycle on
any ancillary component, the exhaust
system or any other non structural
parts of the motorcycle frame.
A correctly supported motorcycle will
help prevent it from falling.
An unstable motorcycle
resulting in motorcycle
serious injury or death.
3
1
may fall
damage,
GENERAL INFORMATION
Left Hand Side Panel
To install the left hand side panel:
Position the bottom of the side
▼
panel onto the lower hook.
Position the two locating dowels to
▼
the grommets, then press firmly to
secure the panel.
Install the fastener at the top of the
▼
side panel and tighten to 40 lbf in
(4.5 Nm).
Finally, grasp the panel and make
▼
sure it is fully retained.
2
clec_1
1. Side panel (Scrambler 400 X shown)
2. Hook
3. Grommets
3
1
55