Triumph Rocket III Classic Service Manual page 408

Fuel System/Engine Management
16. Fit the upper heat shield screws, spring washers and
flat washers, then tighten the screws to 7 Nm.
lZ Fit new gaskets to each silencer.
18. Position the silencer clamps to each catalyst box exit.
19. Fit each silencer to the catalyst box and position to
the silencer brackets.
20. Engage the mounting bracket fixings, finger tight.
21. Tighten each silencer bracket fixing to IS Nm.
22. Tighten each silencer clamp to 22 Nm.
23. Position the heat shields to the silencers.
24. Fit the silencer heat shield screws, spring washers
and flat washers, then tighten the screws to 7 Nm.
25. Reconnect the battery, positive (red) lead first.
26. Fit the seat (see page 17-
17).
Exhaust System - Rocket III Touring
Removal
If the engine has recently been running, the exhaust
components may be hot to the touch. Contact with the
hot components may cause damage to exposed skin.
To avoid skin damage, always allow the hot parts to cool
before working on the exhaust system.
Note:
• The catalytic converters are located with the
silencers. However, in certain countries
(depending on their exhaust emission
regulation) no catalyst will be fitted.
Note:
• Always note the position and orientation of
exhaust clamps prior to releasing them, and
return them to the noted position and
orientation on assembly.
1. Remove the panniers (see page
17-21l.
2. Remove the seat (see page 17-18).
3. Disconnect the battery, negative (black) lead first.
4. Remove the right hand silencer heat shield.
-_--~----~~3~a~
1. Clamp
2. Heat shield front fixing
3. Heat shield
11.204
SelVice Manual - Rocket Ill/ Classic / Touring
(