Triumph Rocket III Classic Service Manual page 374

Fuel System/Engine Management
Installation
1.
Position the airbox to the frame ensuring the semi
circular feature at the front of the airbox is located on
the frame cross tube behind the engine. Attach the
airbox breather hose to the engine and secure it with
the clip before proceeding.
"'"
1. Alrbox
2. Semi-circular feature
3. Frame cross tube
2. Pivot the airbox upwards at the rear and engage the
two bolts that secure it to the frame. TIghten the
bolts to 9 Nm.
3. Refit the intake hose to the airbox and secure it with
the clip.
~"'
1. Clip
2. Intake hose
3. Airbox
Ensure the hose is airbox and is
retained by the clip through its full circumference.
Rectify if necessary as poor engine performance and
engine damage may result from poor hose sealing.
4. Position the intake plenum to the throttle bodies. Fit
and tighten the screws to 6 Nm.
-::::::=::::::~\\~ ~~~
1. Screw
5. Position the intake duct to its bracket, the intake hose
and the intake plenum. Secure the in take hose with
its clip. TIghten the duct fixing to 6 Nm.
Ensure hose
retained by the clip through its circumference.
Rectify if necessary as poor engine performance and
engine damage may result from poor hose sealing.
6. Tighten the three clips to the throttle bodies.
2
\
"'"
1. Throttle bodies
2. Clips
11.170
SelVice Manual - Rocket III / Classic / Touring
(