Table of Contents
Advertisement
Engine Removal and Refit
12.
Rocket III only:
Position the gear change crank to
the selector shaft engaging the splines as noted
during removal.
1.
Selector rod
2. Gear change crank
3. Pinch bolt
13.
For Rocket III Classic and Touring only:
Select
neutral and note the position of the gear change
crank relative to the selector shaft.
,-..::. ======-
cemz1
1.
Gear change crank
2. Selector shaft
14. Fit the pinch bolt to the crank and tighten it to
9Nm.
15. Support the rear brake master cylinder assembly
while aligning the brake pipe joint to the frame
outrigger. Tighten the bolt retaining the brake pipe
joint to 20 Nm.
cbtx
1.
Brake pipe joint
2. Fixing
I<"~~
~1~
16. Position the right hand footrest mounting bar to the
frame and engine.
lZ
Fit and tighten the bar's mounting fixings to 27 Nm.
cbua
1.
Right hand footrest mounting bar
2. Fixings
18. Position the master cylinder to the right hand footrest
mounting bar. Fit and tighten the master cylinder
bolts to 27 Nm.
10.6
SelVice Manual - Rocket III I Classic I Touring
Advertisement
Chapters
Table of Contents
