Triumph Rocket III Classic Service Manual page 390

Fuel System/Engine Management
4. Disconnect the MAP sensor hoses at the T-piece
indicated in the illustration below.
_.
~~
1. Map sensor hose to cylinder number one
2. Map sensor hose to cylinder number two
3. Map sensor hose to cylinder number three
5. Position the analyser in a location that allow it to be
easily read.
• The hose connections on the tool are marked
1, 2, 3 etc. denoting which cylinder they should
be connected to. When connecting the hoses
to the throttles, ensure that hose 1 is
connected to map sensor hose for cylinder
number one etc. Cylinder number one is on the
front of the engine.
1
2
1.
Analyser marking
2. Throttle body connections
6. Using suitable short tubes as adapters, allach the
analyser hoses to the relevant MAP hoses.
1. MAP sensor hoses to cylinders
2. Analyser hoses
Z Ensure that the MAP sensor electrical connector is
disconnected and start the engine.
8. Select the bar chart display on the analyser and
assess which cylinders require adjustment.
Typical display of unbalanced throttles
9. Stop the engine.
Note:
•
If the throttle balance does not require
adjustment, continue from step 15.
11.186
Service Manual - Rocket Ill/Classic / Touring
(
\