Installation - Triumph Rocket III Classic Service Manual

Installation
1. Thoroughly clean and degrease the brake disc.
2. Apply Mobil HP222 grease (or equivalent> to the
wheel driven flange.
3. Position the wheel within the swinging arm.
4. Raise the wheel and engage the driven flange with
the bevel box. Once the splines are engaged, push
the wheel fully home.
1. Wheel
2. Bevel box
WheelslTyres
Z Position the spacer between the wheel and caliper
carrier.
if)
ceve
1. Spacer
8. Align the caliper carrier with the wheel spindle,
spacer and swinging arm. Once in alignment, push
the wheel spindle through the caliper carrier.
9. Align the caliper carrier to the torque reaction fixing
point. Once in alignment, fit a new torque reaction
bolt.
10. Tighten the wheel spindle nut to 110 Nm and the
torque reaction bolt to 69 Nm.
5. Fit the wheel spindle, pushing it through the wheel
centre sufficient to support the wheel without
~
preventing fitment of the spacer and caliper carrier.
Pa
~
cevc1
1.
Wheel spindle
2. Bevel box
6. Position the caliper and carrier over the disc ensuring
both brake pads are correctly aligned either side of
the disc.
1.
Wheel spindle nut
2. Torque reaction bolt
11. Pump the brake pedal to correctly position the
caliper pistons.
12. Check the operation of the rear brake. Rectify as
necessary.
SelVice Manual - Rocket Ill/ Classic / Touring
16.17