Installation
Note:
•
Replacement bearings are supplied with the
plug attached to the outer cup by means of
adhesive. Do not separate these components,
as it is not necessary to do so for installation.
The plug is not an interference fit in the
swinging arm.
1.
Thoroughly clean all debris and dirt from the two
bearing locations in the swinging arm.
Rear Suspension
2.
Press the new bearing outer cups and plugs into
each side of the swinging arm using tool T3880064,
until both are pressed fully up to their locating
shoulders inside the arm.
1.
Bearing outer cup
2. Plug
3. Shoulder (arm shown in section)
4. Tool T3880064
3.
Apply general purpose grease to both bearings
before refitting the swinging arm (see page 13-8>.
SelVice Manual - Rocket
1111
Classic
1
Touring
13.11