Output Shaft Drive Belt Pulley Flange; Removal - Triumph Thunderbird Service Manual

Transmission
Output Shaft Drive Belt Pulley
Flange
1. Pulley flange
2. O-ring
3. Plastic spacer
4. Washer
S. Nut
6. Locking ring
Removal
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
1. Remove the final drive belt (see page 15-8>.
2. Remove the gear position sensor (see page 10-107).
3. Remove the locking ring.
4. Remove the expansion tank bracket lower stud.
Do not rest the pin of tool T3880152 on any part of the
crankcase, always position the tool's pin on the bolt
head as shown below. Use of the tool with the pin
resting on any part of the crankcase will result in severe
damage to the crankcases.
5. Install service tool T3880152 to the pulley flange,
ensuring the pin on the tool rests on the head of the
crankcase bolt as shown below, and secure with the
five bolts removed from the final drive belt pulley.
cfxd
1. Service tool T38801S2
2. Crankcase bolt head
3. Bolt
4. Pulley flange nut
6. Remove the pulley flange nut. Retain the nut for use
during the assembly process.
7.14
SelVice Manual - Thunderbird