Calibration; Pumps; High Level Alarm - Siemens HydroRanger 200 HMI Operating Instructions Manual

Calibration

1. Navigate to
2.2. Calibration
2. Set
2.2.4. Empty
3. Set
2.2.2. Span
4. Set
:
Notes
• Repeat this procedure for the second ultrasonic sensor or when mA input has
been configured.
• Choose Transducer 2 in
• If the HydroRanger 200 HMI is a dual-point model, Transducer 3 will be
available in
the Transducer 1 and Transducer 2 measurements.

Pumps

1. Navigate to
2.8.1.1. Relay Selector
2. Set
2.8.1.2. Level Source
3. Set
based on the values of this measurement.
2.8.1.4. Relay Function
4. Set
2.8.1.5. ON Setpoint
5. Set
2.8.1.6. OFF Setpoint
6. Set
7. Navigate back to
pump, using new setpoint values.
8. If the relay is controlled by the second transducer measurement, set
Source
9. Repeat this procedure for each required relay. Ensure that the correct relay
index is selected in

High level alarm

1. Navigate to
2.8.1.1. Relay Selector
2. Set
2.8.1.2. Level Source
3. Set
2.8.1.4. Relay Function
4. Set
2.8.1.5. ON Setpoint
5. Set
2.8.1.6. OFF Setpoint
6. Set
7. Repeat this procedure for each required relay. Ensure that the correct relay
index is selected in
Page 120 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
2.2. Calibration
.
to Transducer 1 for the first vessel.
to 2.5 meters.
to 2 meters.
2.2. Calibration
2.2. Calibration
for Differential or Average calculations between
2.8. 1 . Basic Setup
.
to Relay 1 to program the first pump.
to Transducer 1. Relay 1 will activiate or de-activate
to Alternate Duty Assist.
. to 1.25 meters.
to 0.25 meters.
2.8.1. 1 . Relay Selector
to Transducer 2.
2.8.1.1. Relay Selector
2.8. 1 . Basic Setup
.
to Relay 1 to program the high level alarm.
to Transducer 1.
Level
to
. to 2 meters.
to 1.75 meters.
2.8.1.1. Relay Selector
.
and select Relay 2 to program the second
.
.
.
2.8.1.2. Level
A5E36281317