Siemens HydroRanger 200 HMI Operating Instructions Manual page 55

Enter one of the following:
• Height of the tank bottom, if
Bottom, Half Sphere Bottom, or Flat Sloped Bottom
• Length of one end section of the tank, if
2. 1 . 1 . Units
Dimension L
Length of the cylindrical section of a horizontal parabolic end vessel.
Dimension L as used in
Index
Values
Enter: Tank length (excluding both end sections) if
Ends.
Maximum Volume
The maximum volume of the vessel.
Enter the vessel volume corresponding to
vessel volume is 8000 L, enter a value of 8000.
For readings in volumetric units (rather than percent), enter the equivalent vessel
2.2.2. Span
volume for
Index
Values
Any volume units can be chosen because volume is calculated from empty to
maximum span, and is scaled according to the
Make sure the selected units allow LCD volume display.
Note:
Examples:
• If max. volume = 3650 m
• If max. volume = 267500 gallons, enter 267.5 (thousands of gallons)
Configure another measurement point
Gives option to configure more measurement points or end the wizard.
Note: This is available on the dual-point model only.
Options
A5E36281317 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
2.7.2. Vessel Shape
or
.
2.7.2. Vessel Shape
Level
Range: 0.0 to 99.00 m or equivalent ,depending on
Preset: 0.000
.
Level
Range: 0.000 to 99999
Preset: 100.0
3
, enter 3650
YES
NO
= Conical Bottom, Parabolic
2.7.2. Vessel Shape
= Parabolic Ends , in
.
2. 1 . 1 . Units
2.7.2. Vessel Shape
2.2.2. Span
. For example, if your maximum
2.7.2. Vessel Shape
Returns to the Measurement Point menu.
Completes the QS Volume configuration.
= Parabolic
value.
Page 45