Parameter default values are indicated with an * in the parameter tables.
Parameter reset
3.2.1. Master Reset
Use conditions:
•
Before initial system installation.
•
Following a software upgrade.
Display readout
The following readouts are shown when the HydroRanger 200 HMI cannot display a
number.
Display
####
Adjusting the Primary Reading:
Parameter
2. 1 2.4. Decimal Position
2. 1 2.5. Convert Reading
2. 1 2.6. Offset Reading
Example
To reference the displayed level to sea level, enter the distance in
2.2.4. Empty
and sea level. (Enter a negative value if Empty is below sea level.)
Sea level
2. 1 2.6. Offset Reading
A5E36281317
returns all parameters to factory default values.
Definition
Parameter has not been set.
Value too large to display.
Action
Sets number of decimals.
Scales the reading to fit.
Shifts the reading up or down by a fixed amount.
2.2.4. Empty
2.2.2. Span
2. 1 2.6. Offset Reading
is the distance between sea level and Empty.
HydroRanger 200 HMI – OPERATING INSTRUCTIONS
2. 1 .1. Units
, between
Reservoir
Page 71