Program Mode; Key Functions In Measurement Mode; Programming The Hydroranger 200 Hmi; Parameter Menus - Siemens HydroRanger 200 HMI Operating Instructions Manual

PROGRAM Mode

The HydroRanger 200 HMI is programmed by setting its parameters to match your
specific application. Most parameters are indexed, allowing you to set the parameter to
specific conditions and to more than one input or output. When the HydroRanger 200
HMI is in PROGRAM mode, you can change these parameter values and set operating
conditions.
The HydroRanger 200 HMI's primary programming is through the four-button interface.
Please refer to page 111 for a full listing and explanation of parameter values.

Key functions in Measurement mode

Key
RIGHT arrow
opens PROGRAM mode.
LEFT arrow
displays the next Auxiliary Read-
ing value in Measurement View
2.
UP or DOWN arrow
toggles between Measurement
View 1 and Measurement View 2.

Programming the HydroRanger 200 HMI

Notes:
• To enter PROGRAM mode using the device local push buttons, press
repeatedly to return to RUN mode.
• While the device is in PROGRAM mode, outputs are de-activated and the device
does not measure the process.
Change parameter settings and set operating conditions to suit your specific application.

Parameter menus

Note: For the complete list of parameters with instructions, see
page 111.
A5E36281317 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Function
Opens the top level menu.
Scrolls through a list of available Auxiliary Read-
ing values, such as Distance, Temperature, or
Milliamp Output. See
Reading on page 173
LCD displays Measurement View 1 or 2.
Result
2. 1 2.7. Default Auxiliary
for a complete list.
. Press
Parameters
on
Page 31