Siemens HydroRanger 200 HMI Operating Instructions Manual page 88

Transducer
Parameter
3.2.6.3. Level
3.2.6.13. Head
1.
To configure the breakpoint table for Level Point 1, set the Trans-
ducer Selector to 1. Enter the appropriate Level and Volume values
into the menus <x.y.z> and <x.y.t> where x.y.z refers to Level and
x.y.t refers to Volume.
Page 78 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Value Description
1
Selector
0.0
0.8
2.0
3.5
4.1
4.7
5.1
5.2
1
5.3
5.4
5.5
5.6
6.0
7.2
9.0
0.0
2.1
4.0
5.6
5.9
6.3
6.7
1
7.1
7.8
8.2
8.8
9.2
10.9
13.0
15.0
Determines the Level breakpoints
at which the volumes are known.
Determines the volumes which
correspond to the level breakpoints.
The universal calculations interpret
between the breakpoints to
produce an accurate model of the
volume at all level readings.
Settings
2.7.2. Vessel Shape
= Universal
Linear (for linear approximation)
2.7.2. Vessel Shape
= Universal
Curved (for curved approximation)
Linear approximation uses a linear
algorithm; curved approximation
uses a cubic spline algorithm.
A5E36281317