Set Relays To Fixed Duty Backup; Set Relays To Service Ratio Duty Assist - Siemens HydroRanger 200 HMI Operating Instructions Manual

Set relays to Fixed Duty Backup

Parameter
2.8.1.4. Relay Function
2.8.1.4. Relay Function
2.8.1.4. Relay Function
Set the Relay ON Setpoints
Parameter
2.8.1.5. ON Setpoint
2.8.1.5. ON Setpoint
2.8.1.5. ON Setpoint
Set the Relay OFF Setpoints
Parameter
2.8.1.6. OFF Setpoint
2.8.1.6. OFF Setpoint
2.8.1.6. OFF Setpoint

Set relays to Service Ratio Duty Assist

Parameter
2.8.1.4. Relay Function
2.8.1.4. Relay Function
2.8.1.4. Relay Function
2.8.1.12. Service Ratio
2.8.1.12. Service Ratio
2.8.1.12. Service Ratio
Set the Relay ON Setpoints
Parameter
2.8.1.5. ON Setpoint
2.8.1.5. ON Setpoint
2.8.1.5. ON Setpoint
Set the Relay OFF Setpoints
Parameter
2.8.1.6. OFF Setpoint
2.8.1.6. OFF Setpoint
2.8.1.6. OFF Setpoint
A5E36281317
Index
1 Fixed Duty Backup Sets the pump relays (Relays
2 Fixed Duty Backup
3 Fixed Duty Backup
Index
1
2
3
Index
1
2
3
Index
1
2
3
1
2
3
Index
1
2
3
Index
1
2
3
HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Mode
1, 2, and 3) to Fixed Duty
Backup. Only one pump will
ever run at one time.
Value Description
0.4 m Sets the three setpoints for the pump
relays. The setpoints remain attached
0.3 m
to the pump relays.
0.2 m
Value Description
1.3 m Sets the three setpoints for the pump
relays.
1.3 m
1.3 m
Mode/Value
Service Ratio Duty Assist
Service Ratio Duty Assist
Service Ratio Duty Assist
25
50
25
Value Description
0.4 m Sets the three setpoints for the pump
relays. The first cycle will use these
0.3 m
setpoints. Subsequent cycles rotate
0.2 m
the setpoints among the pumps.
Value Description
1.3 m Sets the three setpoints for the pump
relays.
1.3 m
1.3 m
Description
Description
Sets the pump
relays (Relays 1, 2,
and 3) to Service
Ratio Duty Assist.
Sets the ratio to:
25% – Pump 1
50% – Pump 2
25% – Pump 3
Page 87