Multiple Readings - Siemens HydroRanger 200 HMI Operating Instructions Manual

Primary Reading is Level and you have chosen Volume for the Auxiliary Reading, the
HydroRanger 200 HMI will always show Level (in the Primary) and Volume (in the
Auxiliary) for the same Level Point. The Level Point is shown in Measurement Mode
Display as caption number 6 on page 28.
Temporarily overriding the Auxiliary Reading
You can temporarily override the value displayed in the Auxiliary Reading by pressing the
button in RUN mode. This allows you to see values in the Auxiliary Reading area that
are not associated with a particular Level Point.
For example, you may have configured the Primary Reading to display Flow, and the
Auxiliary Reading to display Head. If you want to see what the milliamp outputs are, you
can press the
Reading with milliamp output #1. Press the
and press it a third time to see the milliamp input.
The HydroRanger 200 HMI will continue to display your selected temporary value until the
next power cycle. After a power cycle, the HydroRanger 200 HMI will show the default
auxiliary reading (see
Measurement View 2.

Multiple readings

During differential or average operation (
Dual-Point Average
Numbers 1, 2, and 3. Point 3 is the difference between (or average of) Points 1 and 2.
Changing number scrolling speed
Parameter
2. 1 2.8. Display Delay
Page 30 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
button. This first press of
2. 1 2.7. Default Auxiliary Reading on page 173
), Measurement Views 1 and 2 scrolls sequentially through Point
Value
5
will temporarily replace the Auxiliary
button again to display milliamp output #2,
2. 1 .3. Sensor Mode Dual-Point Difference
=
Description
Hold each value for 5 seconds
) when you display
/
A5E36281317