Siemens HydroRanger 200 HMI Operating Instructions Manual page 159

2.8.1.7. Level Selector
2.8.1.8. Pump by Rate
2.8.1.9. Filling Indicator
A5E36281317
For most applications, the relay is reset at this point. For In-bounds
and Out-of-bounds alarms, it is the low point in the specified range.
This parameter is set to
as volume, is shown on the LCD.
Sets the Level Point index for all parameters applicable to this sub-
menu.
Sets the pump relays to accept control by rate of level change once
the first ON setpoint is reached.
Single-point model
Index
Transducer
*OFF (pump by level)
Options
ON
•
•
•
Related
•
•
Use this function when multiple pumps are to be controlled by rate of
level change rather than by setpoints.
The delay between pump starts is set by
Starts
.
This only applies to any relays set to pump control (
Function
= Fixed Duty Assist, Fixed Duty Backup, Alternate Duty
Assist, Alternate Duty Backup, Service Ratio Duty Assist, Service
Ratio Duty Backup, or First In First Out).
Notes:
• All pump control relay ON and OFF setpoints must be the same
value.
• If the level is within 5% of
next pump is not started.
Sets the fill rate required to activate the LCD Filling indicator ( ).
Single-point model
Index
Global
Range: 0.000 to 99.00 m (or equivalent, depending on units)
Values
2.3.4. Response Rate
Altered by
•
•
Related
•
2. 1 . 1 . Units
This value (in
2.3.2. Fill Rate/minute
HydroRanger 200 HMI – OPERATING INSTRUCTIONS
2.2.2. Span
, even when another reading, such
2.2.2. Span
2.8. 1 .4. Relay Function
2.8.2.8. 1 . Delay Between Starts
2.3. Rate
3.2.7. Pump Records
)
2.8.2.8. 1 . Delay Between
2.2.2. Span
of the OFF setpoint, the
2. 1 . 1 . Units
2.2.2. Span
2.3.2. Fill Rate/minute
per minute) is automatically set to 1/10 of
.
Dual-point model
Level
2.8.1.4. Relay
Dual-point model
Transducer
Page 149