Siemens HydroRanger 200 HMI Operating Instructions Manual page 152

2.7.3. Maximum Volume
Enters the maximum volume of the vessel.
Index
Values
Alters
Related
Enter the vessel volume corresponding to
maximum vessel volume is 8000 L, enter a value of 8000.
For readings in volumetric units (rather than percent), enter the equivalent
vessel volume for
Any volume units can be chosen because volume is calculated from empty to
maximum span, and is scaled according to the
Note:
Examples:
• If max. volume = 3650 m
• If max. volume = 267500 gallons, enter 267.5 (thousands of gallons)
2.7.4. Dimension A
Enters the height of the vessel bottom when the bottom is conical, parabolic,
spherical, or flat sloped. If the vessel is horizontal with parabolic ends, the
depth of the end. See 2.7.2. Vessel Shape on page 140 for illustrations.
Dimension A as used in
Index
Values
Related
Enter one of the following:
•
•
Page 142 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Level
Range: 0.000 to 99999
Preset: 100.000
2. 1 2.4. Decimal Position
2.2.4. Empty
•
2.2.2. Span
•
3.2.6. 1 3. Head
•
2.2.2. Span
.
Make sure selected chosen units allow LCD volume display.
3
, enter 3650
2.7.2. Vessel Shape
Level
Range: 0.000 to 99.000 m or equivalent, depending on
Preset: 0.000
2.7.2. Vessel Shape
Height of the tank bottom, if
Parabolic Bottom, Half Sphere Bottom, or Flat Sloped Bottom,
or
Length of one end section of the tank, if
2.1.1. Units
Parabolic Ends , in
2.2.2. Span
. For example, if your
2.7.2. Vessel Shape
.
2.7.2. Vessel Shape
= Conical Bottom,
2.7.2. Vessel Shape
.
value.
2. 1 . 1 . Units
=
A5E36281317