Single-Point Models; Average Or Differential - Siemens HydroRanger 200 HMI Operating Instructions Manual

Single-point models

The HydroRanger 200 HMI starts in Distance mode with the transducer preset for the
XPS-10 and an empty distance of 5 meters. Change the following parameters to reflect
your application parameters.
Parameter
2. 1 .3. Sensor Mode
2. 1 .6. Material
2.3.4. Response Rate
2. 1 .5. Transducer
2. 1 . 1 . Units
2.2.4. Empty
2.2.2. Span

Average or differential

For differential or average operation with a single-point HydroRanger 200 HMI, set
2.1.3. Sensor Mode
Operation to
Average (average) and connect two transducers of the same type. All of the relevant
parameters then become indexed by the correct transducer:
Index
2
3
Page 62 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Value/
Index
Mode
Global *Level
Global Liquid
Global Medium Maximum Process Speed= *Medium (1.0 m/
Global XPS-15
Global Meters
Global 12
Global 10
= Dual-Point Difference (differential) or Dual-Point
Description
Indexed by Transducer 1 or 2
Indexed by Level measurement
1 = Transducer 1
2 = Transducer 2
3 = Calculated Level (average or difference)
Description
Operation = *Level
Material = *Liquid
min)
Read only = XPS-15
Units = Meters
Empty = 12 m
Span = 10 m
A5E36281317