Mounting The Enclosure - Siemens HydroRanger 200 HMI Operating Instructions Manual

Panel mount dimensions

Mounting the enclosure

Once cutout is complete and mounting holes are drilled, follow these steps:
1. Remove the lid from the device by undoing its six lid screws and lifting it off its
hinges.
2. Disconnect the display cable by pressing the locking tab and pulling straight out.
3. Remove the four screws holding the plastic cover and motherboard to the
enclosure.
4. Remove the plastic cover by pulling it straight out. Be careful not to damage the
motherboard electronics with static electricity.
5. Remove the motherboard from the enclosure by pulling the board straight out. Be
careful not to damage the electronics with static electricity.
6. Drill the required cable entry holes. Be sure to compensate for panel door
dimensions and make sure conduit holes do not interfere with the lower areas on
the terminal block, circuit board, or SmartLinx®card.
7. Reinstall the motherboard and plastic cover; secure them with the mounting screws.
8. Reconnect the display cable.
9. Place the unit into the panel and insert hexagonal fasteners through bevel slots and
pre-drilled panel holes.
10. Fasten with wingnuts and hand tighten.
11. Add conduit or glands and wire as required.
Helpful hint: Use tape to hold the hexagonal heads in slots while attaching the wingnuts.
A5E36281317
198 mm
(7.8")
HydroRanger 200 HMI – OPERATING INSTRUCTIONS
31 mm
278 mm
(10.9")
94 mm
(3.7")
(1.2")
Page 15