Siemens HydroRanger 200 HMI Operating Instructions Manual page 48

Start of QS Level Wizard
Shows the type of Wizard to be executed.
Options
Measurement Point Selector
Selects the measurement points to configure.
Note: This is available on the dual-point model only.
Options
Transducer
Specifies the model of the Siemens transducer connected to the device.
Index
Options
Operation
Sets the type of measurement (and the corresponding mA output) required for the
application.
Mode
Out of Service
Level
Space
Distance
Page 38 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
CANCEL
START
Point 1
Point 2
Point 3
Single-point model
Global
*No transducer (dual-point preset)
ST-25
ST-50
STH
XCT-8
*XPS-10 (single-point preset)
XCT-12
XPS-15
XRS-5
mA input
Description
Level Point is not activated.
Height of material
Distance to material surface.
Dual-point model
Transducer
Reference point
Not applicable
2.2.4. Empty
2.2.2. Span
Sensor reference point
A5E36281317