Siemens HydroRanger 200 HMI Operating Instructions Manual page 44

Changing a numeric value
a. Navigate to the desired parameter.
b. When selected, the current value is
displayed.
c. Press RIGHT arrow
mode. The cursor position is highlighted.
d. Use LEFT
move cursor to digit position you wish to
change.
e. As each digit is highlighted (selected),
use the UP
respectively.
f. While decimal point is selected, use UP
position.
g. To escape without saving your changes, press LEFT arrow
is highlighted. Press LEFT arrow
Otherwise, when new parameter value is correct, press RIGHT arrow
continually until OK is highlighted.
h. Press RIGHT arrow
view and displays the new selection. Review for accuracy.
Key functions in Edit mode
Key
Page 34 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
to open Edit
and RIGHT arrow
and DOWN arrow
to accept the new value. The LCD returns to parameter
Name
Selecting
options
UP or
DOWN
Alpha-
arrow
numeric
editing
Selecting
options
RIGHT
arrow
Numeric
editing
Selecting
options
LEFT
arrow
:
Numeric
editing
CALIBRATION
TRANSDUCER SELECTOR
EMPTY
SPAN
SENSOR OFFSET
BLANKING
Parameter
name
SPAN
to
ESC
to increase or decrease the digit
and DOWN arrow
again to escape without saving changes.
Function
Scrolls to item.
- Increments or decrements digits.
- Toggles plus and minus sign.
- Accepts the data (writes the parameter).
- Changes from Edit to Navigation mode.
- Moves cursor one space to the right
- or with selection highlighted, accepts the
data and changes from Edit to Navigation
mode.
Cancels Edit mode without changing the
parameter
- Moves cursor to plus/minus sign if this is the
first key pressed
- or moves cursor one space to the left.
- or with cursor on Enter sign, cancels the entry
Parameter
number
2.2.3
4.670
Current
value
2.2.3
4. 6 7 OK
+ _ _ _ _ _ _
to shift decimal
continually until ESC
A5E36281317