Siemens HydroRanger 200 HMI Operating Instructions Manual page 202

3.2. Diagnostics
3.2.1. Master Reset
Resets all parameters to original values.
Index
Options
Use this feature prior to initial programming if arbitrary parameter values were
used during a bench test, or after upgrading the software. Following a Master
Reset, complete reprogramming is required.
When the factory default option is selected, the display will pause while reset
is processed. When the display returns to the Diagnostics menu, the Master
Reset is complete.
CAUTION: Be careful when using this feature. All data for all points will be
reset. For convenience, be sure to record the values you want to re-enter.
3.2.2. Power-ON Resets
Displays the number of times power has been applied since 3. 1 .9. Manufacture
Date.
Index
Values
Related
3.2.3. Power-ON Time
Displays the number of days this HydroRanger has been in operation.
Index
Values
Related
The RUN Time value is updated once a day, and cannot be reset. However, in
the event of a power interruption, the counter won't advance. Therefore, a unit
that is powered down on a regular basis will not have an accurate value.
3.2.4. Relay Selector
Sets the relay index for all parameters applicable to this sub-menu.
3.2.5. Relay Logic Test
Forces the relay control logic into an activated or de-activated state.
Index
Options
Related
Page 192 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Single-point model
Global
*Do nothing
Factory defaults
Global
Range: 1 to 9999 (Read only)
3. 1 .9. Manufacture Date
•
3.2.3. Power-ON Time
•
Global
Range: 0.000 to 9999 (Read only)
3. 1 .9. Manufacture Date
•
3.2.2. Power-ON Resets
•
Relay
*OFF
Activate relay control
De-activate relay control
2.8. 1 .4. Relay Function
•
Dual-point model
Transducer
A5E36281317