Table of Contents
Advertisement
Service and maintenance
The HydroRanger 200 HMI requires no maintenance or cleaning under normal operating
conditions.
Firmware updates
To update the HydroRanger 200 HMI firmware, please contact your Siemens
representative to obtain the installer (self-executable .exe file). For a complete list of
representatives, go to www.siemens.com/processinstrumentation.
Two installers are available: one to update the firmware in the Human Machine Interface
(HMI) node, and one for the sensor node. One or both may be required, depending on the
reason for the update.
To update, follow the steps below:
1.
Connect your computer to the HydroRanger 200 HMI RJ-11 port.
2.
Before running the .exe installer received from your Siemens representative, note
the computer Comm. Port to which the HydroRanger 200 HMI is connected.
3.
From your computer, double-click the .exe file and follow the installer steps. The first
step will prompt for Communication Options. These options are set to factory
defaults. Ensure the Comm. Port is set to that noted in step 2 above. No other
changes are required.
4.
Follow remaining installer steps.
5.
Once complete, verify the update was successful by checking the current firmware
revision:
•
If updating the HMI node, re-cycle the power on the HydroRanger 200 HMI. On
power-up, you will see the current HMI firmware revision on the HydroRanger
200 HMI display.
•
If updating the sensor node, view parameter
to see the current sensor node firmware revision.
Before re-entering parameters, complete a
defaults after a successful upgrade of the sensor node.
Decontamination declaration
Any device returned to Siemens for repair must be accompanied by a Decontamination
Declaration. With this declaration, you certify that the returned products/spare parts
have been carefully cleaned and are free from any residues.
If the device has been operated together with toxic, caustic, flammable or water-
damaging products, clean the device before return by rinsing or neutralizing. Ensure that
all cavities are free from dangerous substances. Then, doublecheck that the device
completely cleaned.
Siemens will not service a device or spare part unless the declaration confirms proper
decontamination of the device or spare part.
A5E36281317
HydroRanger 200 HMI – OPERATING INSTRUCTIONS
3.1.7. Firmware Revision
3.2. 1 . Master Reset
(page 186) to factory
(page 185)
Page 215
Advertisement
Table of Contents
Troubleshooting
