Quick Start Wizards; Setting Wizards Via Graphical Display - Siemens HydroRanger 200 HMI Operating Instructions Manual

Quick Start Wizards

Wizards provide step-by-step Quick Start (QS) procedures that configure the device for
simple applications. To configure the HydroRanger for applications of Level, Volume (standard
vessel shapes), or Flow, see
The SIMATIC PDM software is meant for applications employing more complex vessel
shapes. See page 251 for more information.
Before initiating a Quick Start Wizard to configure the device, you may wish to gather the
necessary parameter values. Parameter Configuration Charts that list all parameters and
available options for each application type are available at: www.siemens.com/process
automation. You can record data and select from options on the chart that apply to your
application, then with this data on hand, complete the
display
below, or via another Quick Start Wizard, as referenced above.

Setting wizards via graphical display

1) Press RIGHT arrow
1. Wizards
2) Choose
1.1. 1 . QS Level
3) At each step, press DOWN arrow
accept default values and move directly to
the next item, or RIGHT arrow
Edit mode: the current selection is
highlighted.
4) In Edit mode, scroll to desired item and press
RIGHT arrow
press DOWN arrow
5) Repeat steps 3 and 4 until you complete all
the settings and get a prompt to configure
another measurement point or relay (for Pump Control wizard). Pressing
lets you set another point or relay. Pressing
chosen wizard.
6) Press to FINISH and apply the settings made in that particular wizard. The
display will then return to PROGRAM menu. Press
mode.
While configuring the device through the wizards, you can press UP arrow
step back, or LEFT arrow
A5E36281317 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Setting wizards via graphical display
to enter PROGRAM mode.
1. 1 . Quick Start
> , and then the appropriate quick start:
1. 1 .2. QS Volume 1.1.3. QS Flow
, ,
to store the change, then
to continue.
to cancel.
Setting wizards via graphical
1.2. Pump Control
, or
to
QUICK START LEVEL
to open
QUICK START LEVEL
TRANSDUCER
for NO takes you to the end of the
to return to Measurement
below.
.
TRANSDUCER
XPS-10
BACK
CANCEL EDIT
NEXT
XCT-8
XPS-10
XCT-12
XPS-15
XRS-5
for YES
to go one
Page 35