Siemens HydroRanger 200 HMI Operating Instructions Manual page 169

2.10.1.3. Relay Duration
2. 1 0. 1 .3. Relay Duration
Relay contact closed
Relay contact open
2.10.2. External Sampler
2.10.2.1. Transducer Selector
2.10.2.2. Mantissa
A5E36281317
Use this feature (if desired) to adjust the minimum contact closure
duration of a relay set as a totalizer or flow sampler (2.8. 1 .4. Relay
Function = Totalizer or Flow Sampler).
Global
Index
Range: 0.1 to 1024 seconds
Values
Preset: 0.188 seconds
2.8. 1 .4. Relay Function
Related
Enter minimum contact closure duration (in seconds) required by the
device connected.
ON time
Sets the transducer index for all parameters applicable to this sub-
menu.
Establishes the number of flow units required to increment the Flow
Sampler (the device connected to the relay set to 2.8. 1 .4. Relay
Function = Flow Sampler), in conjunction with 2.10.2.3. Exponent.
Single-point model
Index
Global
Range: 0.001 to 9999
Values
Preset: 1.000
•
•
•
•
•
•
•
•
Related
•
•
•
•
•
•
•
This parameter is relevant only if Operation is set to OCM (
Sensor Mode Flow rate in open channel
=
Enter the mantissa (Y) for the exponent (Z) in the formula:
Flow Sampler Increment = Y x 10
HydroRanger 200 HMI – OPERATING INSTRUCTIONS
2. 1 0. 1 .3. Relay Duration
2. 1 .3. Sensor Mode
2.8. 1 .4. Relay Function
2. 1 3.2. Primary Measuring Device
2. 1 3.4. 1 . Flow Exponent
2. 1 3.5. PMD Dimensions
2. 1 3.4.2. Maximum Head
2. 1 3.4.3. Maximum Flow
2. 1 3.4.5. Zero Head
2. 1 3.4.4. Flow Time Units
2. 1 3.4.6. Flowrate Decimal
2. 1 3.6. 1 . 1 . Head 1
2. 1 3.6. 1 .2. Flow 1
2. 1 3.4.8. Low Flow Cutoff
2. 1 3.3. Auto Zero Head
)
2. 1 0.2.3. Exponent
).
Z
Flow units.
OFF time
Dual-point model
Transducer
2. 1 .3.
Page 159