Setting A Pump Up (Reservoir) Group - Siemens HydroRanger 200 HMI Operating Instructions Manual

Set relays to Alternate Duty Assist
Parameter
2.8.1.4. Relay Function
2.8.1.4. Relay Function
2.8.1.4. Relay Function
Set the ON setpoints
Parameter
2.8.1.5. ON Setpoint
2.8.1.5. ON Setpoint
2.8.1.5. ON Setpoint
Set the OFF setpoints
Parameter
2.8.1.6. OFF Setpoint
2.8.1.6. OFF Setpoint
2.8.1.6. OFF Setpoint

Setting a Pump Up (Reservoir) Group

Set a group of three pumps to pump up a reservoir.
Page 84 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Index
1
2
3
Index
1
2
3
Index
1
2
3
HydroRanger 200 HMI
2.2.2. Span
Inflow
Mode
Alternate Duty Assist
Alternate Duty Assist
Alternate Duty Assist
Value Description
1.0 m Sets the three setpoints for the pump
relays. The first cycle will use these
1. 1 m
setpoints. Subsequent cycles rotate
1.2 m
the setpoints among the pumps.
Value Description
0.5 m Sets the three setpoints for the pump
relays. The first cycle will use these
0.5 m
setpoints. Subsequent cycles rotate
0.5 m
the setpoints among the pumps.
2.2.4. Empty
Outflow
Description
Sets the pump relays
(Relays 1, 2, and 3) to
Alternate Duty Assist.
A5E36281317