Cable exposed and entering through the cable glands
1.
Unscrew the glands and attach them loosely to the enclosure.
2.
Thread the cables through the glands. To avoid interference, ensure that the power
cable is kept separated from the signal cables, and then wire the cables to the
terminal blocks.
3.
Tighten the glands to form a good seal.
Where more holes are required than are supplied in the enclosure, follow
Note:
the instructions on
A5E36281317
Cable routed through a conduit
HydroRanger 200 HMI – OPERATING INSTRUCTIONS
on page 12.
Page 13