Siemens HydroRanger 200 HMI Operating Instructions Manual page 59

Units
Sensor measurement units.
Options
Note: For the purpose of this example, all values are assumed to be in meters.
Empty
Sets the distance from the face of the transducer to the process empty point.
Index
Values
Span
Sets the range to be measured.
Index
Options
Response Rate
Sets the reaction speed of the device to measurement changes in the target range.
Notes:
• Response Rate can only be set through the Quick Start Wizard, and any
changes made to
following the completion of the wizard will supersede the Response Rate
setting.
• Response Rate always displays in meters per minute (m/min).
Index
Options
Use a setting just faster than the maximum filling or emptying rate (whichever is
greater). Slower settings provide higher accuracy, faster settings allow for more
level fluctuations.
Primary Measuring Device
The type of primary measuring device (PMD) used.
Index
A5E36281317 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
*M (meters)
CM (centimeters)
MM (millimeters)
FT (feet)
IN (inches)
Level
Range: 0.000 to 99.000 m
Preset: 5.000 m
Level
Range: 0.000 to 99.000 m (or equivalent, depending on
2.2.4. Empty
Preset: based on
2.3.2. Fill Rate/minute
Transducer
Slow (0.1 m/min)
*Medium (1.0 m/min)
Fast (10.0 m/min)
Single-point model Dual-point model
2. 1 . 1 . Units
2.3.3. Empty Rate/minute
or
)
parameters
Page 49