Siemens HydroRanger 200 HMI Operating Instructions Manual page 153

2.7.5. Dimension L
Enters the length of the cylindrical section of a horizontal parabolic end vessel.
See 2.7.2. Vessel Shape on page 140 for illustrations.
Dimension L as used in
Index
Values
Related
Enter the tank length (excluding both end sections) if
Parabolic Ends.
2.7.6. Transducer Selector
Sets the transducer index for all parameters applicable to this sub-menu.
2.7.7. Inflow/discharge Adjust
The method used to calculate the volume pumped, for pumped total (2. 1 .3.
Sensor Mode = Pump Totalizer)
Index
Options
Related
2.7.8. Table 1-8
Allows for the Volume to be specified based on segments, if the tank shape is
too complex for any of the preconfigured shapes.
Enter up to 32 Level and Volume breakpoints (where Volume is known), if
Vessel Shape
Each segment defined by the Level breakpoints (example: Level 1) requires
a Volume (example: Volume 1) for the level-to-volume calculations.
2.7.8.1. Level 1
2.7.8.2. Volume 1
2.7.8.3. Level 2
2.7.8.4. Volume 2
2.7.8.5. Level 3
2.7.8.6. Volume 3
2.7.8.7. Level 4
2.7.8.8. Volume 4
2.7.8.9. Level 5
2.7.8.10. Volume 5
A5E36281317
2.7.2. Vessel Shape
Level
Range: 0.000 to 99.000 m or equivalent, depending on
Preset: 0.000
2.7.2. Vessel Shape
Single-point model
Global
Based on Pump Cycle
No adjustment
*Based on Rate Estimation
2. 1 .3. Sensor Mode
•
2.3.5. Rate Filter
•
2.3.6. Rate Filter Time
•
2.3.7. Rate Filter Distance
•
3.2.7. Pump Records
•
is set to Universal Linear or Universal Curved.
HydroRanger 200 HMI – OPERATING INSTRUCTIONS
.
.
Dual-point model
Transducer
2. 1 . 1 . Units
2.7.2. Vessel Shape
=
2.7.2.
Page 143