Siemens HydroRanger 200 HMI Operating Instructions Manual page 140

Values
Related
This feature is useful in OCM applications where the Empty level is set to the
bottom of the weir, and above the bottom of the channel, and should be used if
the surface monitored can fall past the
The value is added to
transducer. If the surface monitored can extend beyond
2.2.7. Range Extension
greater than the transducer face to furthest surface to be monitored distance.
This is often the case with OCM when using weirs and some flumes.
2.3. Rate
2.3.1. Transducer Selector
Sets the transducer index for all parameters applicable to this sub-menu.
2.3.2. Fill Rate/minute
Adjusts the device's response to increases in the actual material level (or
advance to a higher 2.4.5. Material Level).
Index
Values
Altered by
Related
Enter a value slightly greater than the maximum vessel filling rate. This value,
2.1.1. Units
in
altered.
2.3.3. Empty Rate/minute
Adjusts the device's response to decreases in the actual material level (or
advance to a lower 2.4.5. Material Level).
Index
Page 130 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Range: 0.000 to 99.00 m, or max.
2. 1 . 1 . Units
on
Preset: 20% of
2. 1 . 1 . Units
•
2.2.4. Empty
•
2.2.2. Span
•
2. 1 .5. Transducer
•
2.2.4. Empty
2.1.1. Units
(in
Single-point model
Global
Range: 0.000 to 99.00 m (or equivalent, depending on
2.3.4. Response Rate
2. 1 . 1 . Units
•
2.2.2. Span
•
2.4.5. Material Level
•
per minute, is automatically altered when
2.3.4. Response Rate
1
2
3
Single-point model
Global
2.2.2. Span
2.2.2. Span
2.2.4. Empty
and can be greater than the range of the
) such that Empty plus Range Extension is
Dual-point model
Transducer
Value Meters/minute
Dual-point model
Transducer
, or equivalent, depending
level in normal operation.
2.2.4. Empty
, increase
2. 1 . 1 . Units
)
2.3.4. Response Rate
0.1
1
10
A5E36281317
is