Siemens HydroRanger 200 HMI Operating Instructions Manual page 136

2.1.11. Number of Short Shots
Sets the number of short shots to be fired (and results averaged) per transmit
pulse.
Index
Values
Related
2.1.12. Number of Long Shots
Sets the number of long shots to be fired (and results averaged) per transmit
pulse.
Index
Values
Altered by
Related
This value is automatically altered by
2.1.13. Shot Synchro
Enables the System Sync on the terminal block.
Index
Options
Use this if another level measurement system is mounted nearby, and wired
together on the Sync terminal.
2.1.14. Scan Delay
Adjusts the delay between measurements from transducer points, in seconds.
Dual-point model only.
Index
Values
Altered by
Related
This feature may only be used to adjust the delay before the next point is
scanned. This value is automatically altered when
altered.
Page 126 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Single-point model
Global
Range: 0 to 100
Preset: 1
2. 1 . 1 2. Number of Long Shots
•
2. 1 .7. Short Shot Frequency
•
2. 1 . 1 0. Long Shot Duration
•
2. 1 1.2. 1 0. Short Shot Bias
•
2. 1 1.2. 1 1. Short Shot Floor
•
2. 1 1.2. 1 2. Short Shot Range
•
Single-point model
Global
Range: 0 to 200
Preset: 5
2.3.4. Response Rate
2. 1 . 1 1. Number of Short Shots
•
2. 1 .8. Long Shot Frequency
•
2. 1 .9. Short Shot Duration
•
2.3.4. Response Rate
Global
Not required
*Synchronize level monitors
Global
Range: 0 to 60 seconds
Preset: 5
2.3.4. Response Rate
2. 1 .3. Sensor Mode
Dual-point model
Transducer
Dual-point model
Transducer
.
2.3.4. Response Rate
A5E36281317
is