Siemens HydroRanger 200 HMI Operating Instructions Manual page 142

Options
Alters
Altered by
Related
Enter the time or distance interval over which the
be calculated before the display updates.
This is automatically altered along with
This value automatically alters the
Filter Distance
independently.
2.3.6. Rate Filter Time
The time period, in seconds, over which the material level rate of change is
averaged before 3.2.6.15. Flow Maximum updates.
Index
Values
Related
2.3.7. Rate Filter Distance
The material level change, in meters, to initiate a
Index
Values
Related
2.3.8. Level Selector
Sets the Level Point index for all parameters applicable to this sub-menu.
2.3.9. Filling Indicator
The fill rate required to activate the LCD Filling indicator ( ).
Index
Values
Altered by
Related
Page 132 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Rate display not required.
Filtered Output:
Continuous filtering and update
Interval Output:
*1 min or 50 mm (2 in)
5 min or 100 mm (3.9 in)
10 min or 300 mm (11.8 in)
10 min or 1000 mm (39.4 in)
3.2.6. 1 5. Flow Maximum
2.3.4. Response Rate
2.3.6. Rate Filter Time
2.3.7. Rate Filter Distance
2.3.6. Rate Filter Time
. Alternatively, these parameter values may be altered
Single-point model
Global
Range: 0.000 to 9999 seconds
3.2.6. 1 5. Flow Maximum
Single-point model
Global
Range: 0.000 to 9999 meters
3.2.6. 1 5. Flow Maximum
Single-point model
Global
Range: 0.000 to 99.00 m (or equivalent, depending on
2.3.4. Response Rate
2. 1 . 1 . Units
•
2.2.2. Span
•
2.3.2. Fill Rate/minute
•
3.2.6.15. Flow Maximum
2.3.4. Response Rate
.
and/or
Dual-point model
Transducer
3.2.6. 1 5. Flow Maximum
Dual-point model
Transducer
Dual-point model
Transducer
is to
2.3.7. Rate
update.
2. 1 . 1 . Units
)
A5E36281317