Siemens HydroRanger 200 HMI Operating Instructions Manual page 200

2.14.3. Running Totalizer Low
Shows and/or alters the four least significant digits of the totalizer value.
Primary Index
Values
Related
2.14.4. Totalizer Decimal Position
Sets the maximum number of decimal places to be displayed.
Index
Options
Related
Note:
HydroRanger 200 HMI. If the position is changed later, the totalizer data in
2. 1 4.2. Running Totalizer High
incorrect and must be reset according to the new decimal value.
In RUN mode, the number of decimal places displayed is not automatically
adjusted. When the LCD Total value is so large as to exceed display
capabilities, the total rolls over to 0 and continues incrementing.
2.14.5. Totalizer Multiplier
Use this feature if the LCD Total increments by too large (or too small) an
amount.
Index
Options
Related
Page 190 HydroRanger 200 HMI – OPERATING INSTRUCTIONS
Single Point Model
Global
Range: 0.000 to 9999
2. 1 4.2. Running Totalizer High
•
2. 1 4.4. Totalizer Decimal Position
•
2. 1 4.5. Totalizer Multiplier
•
Single-point model
Global
No digits
1 digit
*2 digits
3 digits
2. 1 4.2. Running Totalizer High
2. 1 4.3. Running Totalizer Low
Set the decimal position during initial commissioning of the
Single-point model
Global
0.001
0.01
0. 1
*1
10
100
1,000
10,000
100,000
1,000,000
10,000,000
2. 1 4.2. Running Totalizer High
2. 1 4.3. Running Totalizer Low
Transducer
Dual-point model
Transducer
2.14.3. Running Totalizer Low
and
Dual-point model
Transducer
Dual Point Model
will be
A5E36281317