Waveform Commands - Agilent Technologies MSO6102A Programmer's Reference Manual

3
Commands by Subsystem

:WAVeform Commands

Provide access to waveform data. See
Commands"
Table 76 :WAVeform Commands Summary
Command
:WAVeform:BYTeorder
<value> (see page 444)
n/a
n/a
:WAVeform:FORMat
<value> (see page 448)
:WAVeform:POINts
<# points> (see
page 449)
:WAVeform:POINts:MODE
<points_mode> (see
page 451)
436
on page 438.
Query
:WAVeform:BYTeorder?
(see page 444)
:WAVeform:COUNt? (see
page 445)
:WAVeform:DATA? (see
page 446)
:WAVeform:FORMat? (see
page 448)
:WAVeform:POINts? (see
page 449)
:WAVeform:POINts:MODE?
(see page 452)
"Introduction to :WAVeform
Options and Query Returns
<value> ::= {LSBFirst | MSBFirst}
<count> ::= an integer from 1 to
65536 in NR1 format
<binary block length bytes>, <binary
data>
For example, to transmit 1000 bytes
of data, the syntax would be:
#800001000<1000 bytes of data><NL>
8 is the number of digits that
follow
00001000 is the number of bytes to
be transmitted
<1000 bytes of data> is the actual
data
<value> ::= {WORD | BYTE | ASCII}
<# points> ::= {100 | 250 | 500 |
1000 | <points_mode>} if waveform
points mode is NORMal
<# points> ::= {100 | 250 | 500 |
1000 | 2000 ... 8000000 in 1-2-5
sequence | <points_mode>} if
waveform points mode is MAXimum or
RAW
<points_mode> ::= {NORMal | MAXimum
| RAW}
<points_mode> ::= {NORMal | MAXimum
| RAW}
Agilent 6000 Series Oscilloscopes Programmer's Reference