Measure:vstart - Agilent Technologies MSO6102A Programmer's Reference Manual

:MEASure:VSTArt

Command Syntax
:MEASure:VSTArt <vstart_argument>
<vstart_argument> ::= value for vertical marker 1
The :MEASure:VSTArt command moves the vertical marker (Y1 cursor) to
the specified value corresponding to the selected source. The source can
be selected by the MARKer:X1Y1source command.
The short form of this command, VSTA, does not follow the defined Long Form to Short
N O T E
Form Truncation Rules (see
both VSTArt and VSTOp, so sending VST for the VSTArt command produces an error.
The :MEASure:VSTArt command is an obsolete command provided for compatibility to
N O T E
previous oscilloscopes. Use the :MARKer:Y1Position command (see
Query Syntax
:MEASure:VSTArt?
The :MEASure:VSTArt? query returns the current value of the Y1 cursor.
Return Format
<value><NL>
<value> ::= voltage at voltage marker 1 in NR3 format
See Also
•
•
•
•
•
•
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see page 564)
"Introduction to :MARKer Commands"
"Introduction to :MEASure Commands"
":MARKer:Y1Position"
":MARKer:Y2Position"
":MARKer:YDELta" on page 242
":MARKer:X1Y1source"
":MEASure:SOURce"
":MEASure:TDELta" on page 513
":MEASure:TSTArt" on page 517
Obsolete and Discontinued Commands
page 566). The normal short form, VST, would be the same for
on page 233
on page 248
on page 240
on page 241
on page 236
on page 270
5
page 240) instead.
523