Marker:ydelta - Agilent Technologies MSO6102A Programmer's Reference Manual

3
Commands by Subsystem

:MARKer:YDELta

Query Syntax
:MARKer:YDELta?
The :MARKer:YDELta? query returns the value difference between the
current Y1 and Y2 cursor positions.
Ydelta = (Value at Y2 cursor) - (Value at Y1 cursor)
If the front-panel cursors are off or are set to Binary or Hex Mode, the marker position
N O T E
values are not defined. Make sure to set :MARKer:MODE to MANual to put the cursors in
the front-panel Normal mode.
Return Format
<value><NL>
<value> ::= difference value in NR3 format
See Also
•
•
•
•
•
•
242
(see page 564)
"Introduction to :MARKer Commands"
":MARKer:MODE" on page 234
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MARKer:Y1Position"
":MARKer:Y2Position"
on page 233
on page 236
on page 238
on page 240
on page 241
Agilent 6000 Series Oscilloscopes Programmer's Reference