:MARKer:Y2Position
Command Syntax
:MARKer:Y2Position <position> [suffix]
<position> ::= Y2 cursor position in NR3 format
<suffix> ::= {mV | V | dB}
The :MARKer:Y2Position command sets :MARKer:MODE to MANual, sets
the Y2 cursor position and moves the Y2 cursor to the specified value.
Query Syntax
:MARKer:Y2Position?
The :MARKer:Y2Position? query returns current Y2 cursor position. If the
front- panel cursors are off an error is returned. This is functionally
equivalent to the obsolete :MEASure:VSTOp command/query.
Return Format
<position><NL>
<position> ::= Y2 cursor position in NR3 format
See Also
•
•
•
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see
page
564)
"Introduction to :MARKer Commands"
":MARKer:MODE"
on page 234
":MARKer:X1Y1source"
":MARKer:X2Y2source"
":MARKer:Y1Position"
":MEASure:VSTOp"
on page 524
on page 233
on page 236
on page 238
on page 240
Commands by Subsystem
3
241