Trigger:eburst:slope - Agilent Technologies MSO6102A Programmer's Reference Manual

:TRIGger:EBURst:SLOPe

Command Syntax
:TRIGger:EBURst:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:EBURst:SLOPe command specifies whether the rising edge
(POSitive) or falling edge (NEGative) of the Nth edge in a burst will
generate a trigger.
Query Syntax
:TRIGger:EBURst:SLOPe?
The :TRIGger:EBURst:SLOPe? query returns the current Nth edge in a
burst slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see page 564)
"Introduction to :TRIGger Commands"
":TRIGger:EBURst:IDLE"
":TRIGger:EBURst:COUNt"
on page 332
on page 362
on page 361
Commands by Subsystem
3
363