Acquire Commands - Agilent Technologies MSO6102A Programmer's Reference Manual

3
Commands by Subsystem

:ACQuire Commands

Set the parameters for acquiring and storing data. See
:ACQuire Commands"
Table 47 :ACQuire Commands Summary
Command
n/a
:ACQuire:COMPlete
<complete> (see
page 141)
:ACQuire:COUNt <count>
(see page 142)
:ACQuire:DAALias <mode>
(see page 143)
:ACQuire:MODE <mode>
(see page 144)
n/a
:ACQuire:RSIGnal
<ref_signal_mode> (see
page 146)
n/a
:ACQuire:TYPE <type>
(see page 148)
Introduction to The ACQuire subsystem controls the way in which waveforms are
:ACQuire
acquired. These acquisition types are available: normal, averaging, peak
Commands detect, and high resolution. Two acquisition modes are available: real- time
mode, and equivalent- time mode.
Normal
The :ACQuire:TYPE NORMal command sets the oscilloscope in the normal
acquisition mode. For the majority of user models and signals, NORMal
mode yields the best oscilloscope picture of the waveform.
Averaging
138
on page 138.
Query
:ACQuire:AALias? (see
page 140)
:ACQuire:COMPlete? (see
page 141)
:ACQuire:COUNt? (see
page 142)
:ACQuire:DAALias? (see
page 143)
:ACQuire:MODE? (see
page 144)
:ACQuire:POINts? (see
page 145)
:ACQuire:RSIGnal? (see
page 146)
:ACQuire:SRATe? (see
page 147)
:ACQuire:TYPE? (see
page 148)
Options and Query Returns
{1 | 0}
<complete> ::= 100; an integer in
NR1 format
<count> ::= an integer from 1 to
65536 in NR1 format
<mode> ::= {DISable | AUTO}
<mode> ::= {RTIMe | ETIMe}
<# points> ::= an integer in NR1
format
<ref_signal_mode> ::= {OFF | OUT |
IN}
<sample_rate> ::= sample rate
(samples/s) in NR3 format
<type> ::= {NORMal | AVERage |
HRESolution | PEAK}
Agilent 6000 Series Oscilloscopes Programmer's Reference
"Introduction to