:TRIGger:FLEXray:FRAMe:CCBase
Command Syntax
:TRIGger:FLEXray:FRAMe:CCBase <cycle_count_base>
<cycle_count_base> ::= integer from 0-63
The :TRIGger:FLEXray:FRAMe:CCBase command sets the base of the
FlexRay cycle count (in the frame header) to trigger on. The cycle count
base setting is only valid when the FlexRay trigger mode is set to FRAME.
This command is only valid when the FLEXray triggering and serial decode option (Option
N O T E
FRS) has been licensed.
Query Syntax
:TRIGger:FLEXray:FRAMe:CCBase?
The :TRIGger:FLEXray:FRAMe:CCBase? query returns the current cycle
count base setting for the FlexRay frame trigger setup.
Return Format
<cycle_count_base><NL>
<cycle_count_base> ::= integer from 0-63
Errors
•
See Also
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see
page
564)
"- 241, Hardware missing"
"Introduction to :TRIGger Commands"
":TRIGger:FLEXray:TRIGger"
on page 535
on page 332
on page 381
Commands by Subsystem
3
373