Trigger:pattern - Agilent Technologies MSO6102A Programmer's Reference Manual

3
Commands by Subsystem

:TRIGger:PATTern

Command Syntax
:TRIGger:PATTern <pattern>
<pattern> ::= <value>, <mask> [, <edge source>, <edge>]
<value> ::= 32-bit integer or <string>
<mask> ::= 32-bit integer or <string>
<string> ::= "0xnnnnnn"; n ::= {0,..,9 | A,..,F}
<edge source> ::= {CHANnel<n> | EXTernal | NONE} for DSO models
<edge source> ::= {CHANnel<n> | DIGital0,..,DIGital15
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
<edge> ::= {POSitive | NEGative}
The :TRIGger:PATTern command defines the specified pattern resource
according to the value and the mask. For both<value> and <mask>, each
bit corresponds to a possible trigger channel. The bit assignments vary by
instrument:
Oscilloscope Models
4 analog + 16 digital channels (mixed-signal)
2 analog + 16 digital channels (mixed-signal)
4 analog channels only
2 analog channels only
Set a <value> bit to "0" to set the pattern for the corresponding channel to
low. Set a <value> bit to "1" to set the pattern to high.
Set a <mask> bit to "0" to ignore the data for the corresponding channel.
Only channels with a "1" set on the appropriate mask bit are used.
The optional source and the optional edge should be sent together or not at all. The edge
N O T E
will be set in the simple pattern if it is included. If the edge source is also specified in the
mask, the edge takes precedence.
340
(see page 564)
| NONE} for MSO models
Value and Mask Bit Assignments
Bits 0 through 15 - digital channels 0 through
15. Bits 16 through 19 - analog channels 1
through 4.
Bits 0 through 15 - digital channels 0 through
15. Bits 16 and 17 - analog channels 1 and 2.
Bits 0 through 3 - analog channels 1 through 4.
Bit 4 - external trigger.
Bits 0 and 1 - analog channels 1 and 2. Bit 4 -
external trigger.
Agilent 6000 Series Oscilloscopes Programmer's Reference