Sbus:mode - Agilent Technologies MSO6102A Programmer's Reference Manual

3
Commands by Subsystem

:SBUS:MODE

Command Syntax
:SBUS:MODE <mode>
<mode> ::= {IIC | SPI | CAN | LIN | FLEXray}
The :SBUS:MODE command determines the decode mode for the serial
bus.
This command is only valid on 4-channel or 4+16-channel oscilloscope models when a
N O T E
serial decode option has been licensed.
Query Syntax
:SBUS:MODE?
The :SBUS:MODE? query returns the current serial bus decode mode
setting.
Return Format
<mode><NL>
<mode> ::= {IIC | SPI | CAN | LIN | FLEX | NONE}
Errors •
See Also •
•
•
•
•
•
310
(see page 564)
"- 241, Hardware missing"
"Introduction to :SBUS Commands"
":TRIGger:MODE" on page 338
":TRIGger:IIC Commands"
":TRIGger:SPI Commands"
":TRIGger:CAN Commands"
":TRIGger:LIN Commands"
on page 535
on page 293
on page 391
on page 416
on page 343
on page 400
Agilent 6000 Series Oscilloscopes Programmer's Reference