Display Commands - Agilent Technologies MSO6102A Programmer's Reference Manual

:DISPlay Commands

Control how waveforms, graticule, and text are displayed and written on
the screen. See
Table 52 :DISPlay Commands Summary
Command
:DISPlay:CLEar (see
page 195)
:DISPlay:DATA
[<format>][,][<area>][,
][<palette>]<display
data> (see page 196)
:DISPlay:LABel {{0 |
OFF} | {1 | ON}} (see
page 198)
:DISPlay:LABList
<binary block> (see
page 199)
:DISPlay:PERSistence
<value> (see page 200)
:DISPlay:SOURce <value>
(see page 201)
:DISPlay:VECTors {{1 |
ON} | {0 | OFF}} (see
page 202)
Introduction to
The DISPlay subsystem is used to control the display storage and retrieval
:DISPlay of waveform data, labels, and text. This subsystem allows the following
Commands
actions:
• Clear the waveform area on the display.
• Turn vectors on or off.
• Set waveform persistence.
Agilent 6000 Series Oscilloscopes Programmer's Reference
"Introduction to :DISPlay Commands"
Query
n/a
:DISPlay:DATA?
[<format>][,][<area>][,
][<palette>] (see
page 196)
:DISPlay:LABel? (see
page 198)
:DISPlay:LABList? (see
page 199)
:DISPlay:PERSistence?
(see page 200)
:DISPlay:SOURce? (see
page 201)
:DISPlay:VECTors? (see
page 202)
Commands by Subsystem
on page 193.
Options and Query Returns
n/a
<format> ::= {TIFF} (command)
<area> ::= {GRATicule} (command)
<palette> ::= {MONochrome} (command)
<format> ::= {TIFF | BMP | BMP8bit |
PNG} (query)
<area> ::= {GRATicule | SCReen}
(query)
<palette> ::= {MONochrome |
GRAYscale | COLor} (query)
<display data> ::= data in IEEE
488.2 # format
{0 | 1}
<binary block> ::= an ordered list
of up to 75 labels, each 6
characters maximum, separated by
newline characters
<value> ::= {MINimum | INFinite}}
<value> ::= {PMEMory{0 | 1 | 2 | 3 |
4 | 5 | 6 | 7 | 8 | 9}}
{1 | 0}
3
193