Trigger[:Edge]:Slope - Agilent Technologies MSO6102A Programmer's Reference Manual

3
Commands by Subsystem

:TRIGger[:EDGE]:SLOPe

Command Syntax
:TRIGger[:EDGE]:SLOPe <slope>
<slope> ::= {NEGative | POSitive | EITHer | ALTernate}
The :TRIGger[:EDGE]:SLOPe command specifies the slope of the edge for
the trigger. The SLOPe command is not valid in TV trigger mode. Instead,
use :TRIGger:TV:POLarity to set the polarity in TV trigger mode.
Query Syntax
:TRIGger[:EDGE]:SLOPe?
The :TRIGger[:EDGE]:SLOPe? query returns the current trigger slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS | EITH | ALT}
See Also
•
•
•
Example Code
Example program from the start:
page 614
368
(see page 564)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 338
":TRIGger:TV:POLarity"
' TRIGGER_EDGE_SLOPE - Sets the slope of the edge for the trigger.
' Set the slope to positive.
myScope.WriteString ":TRIGGER:EDGE:SLOPE POSITIVE"
on page 332
on page 428
"VISA COM Example in Visual Basic"
Agilent 6000 Series Oscilloscopes Programmer's Reference
on