Measure:vtime - Agilent Technologies MSO6102A Programmer's Reference Manual

:MEASure:VTIMe

Query Syntax
:MEASure:VTIMe? <vtime_argument>[,<source>]
<vtime_argument> ::= time from trigger in seconds
<source> ::= {<digital channels> | CHANnel<n> | FUNCtion | MATH}
<digital channels> ::= DIGital0,..,DIGital15 for the MSO models
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :MEASure:VTIMe? query returns the value at a specified time on the
source specified with :MEASure:SOURce. The specified time must be on
the screen and is referenced to the trigger event. If the optional source
parameter is specified, the current source is modified.
This query is not available if the source is FFT (Fast Fourier Transform).
N O T E
Return Format
<value><NL>
<value> ::= value at the specified time in NR3 format
See Also •
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see page 564)
"Introduction to :MEASure Commands"
":MEASure:SOURce"
":MEASure:TEDGe" on page 272
":MEASure:TVALue" on page 274
on page 248
on page 270
Commands by Subsystem
3
283