Trigger[:Edge]:Reject - Agilent Technologies MSO6102A Programmer's Reference Manual

:TRIGger[:EDGE]:REJect

Command Syntax
:TRIGger[:EDGE]:REJect <reject>
<reject> ::= {OFF | LFReject | HFReject}
The :TRIGger[:EDGE]:REJect command turns the low- frequency or
high- frequency reject filter on or off. You can turn on one of these filters
at a time.
• The high frequency reject filter adds a 50 kHz low- pass filter in the
• The low frequency reject filter adds a 50 kHz high- pass filter in series
The :TRIGger[:EDGE]:REJect and the :TRIGger[:EDGE]:COUPling selections are coupled.
N O T E
Changing the setting of the :TRIGger[:EDGE]:COUPling can change the COUPling setting.
Query Syntax
:TRIGger[:EDGE]:REJect?
The :TRIGger[:EDGE]:REJect? query returns the current status of the reject
filter.
Return Format
<reject><NL>
<reject> ::= {OFF | LFR | HFR}
See Also •
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
(see page 564)
trigger path to remove high frequency components from the trigger
waveform. Use the high frequency reject filter to remove high- frequency
noise, such as AM or FM broadcast stations, from the trigger path.
with the trigger waveform to remove any unwanted low frequency
components from a trigger waveform, such as power line frequencies,
that can interfere with proper triggering.
"Introduction to :TRIGger Commands"
":TRIGger:HFReject" on page 336
":TRIGger[:EDGE]:COUPling"
Commands by Subsystem
on page 332
on page 365
3
367